Ceiling Fan Remote Control Not Working

This tells you that the fan remote control is sending a signal to the fan receiver.

Ceiling fan remote control not working.

If two or more ceiling fans have the same frequency they can be controlled by either fan s remote which can have a range of 40 to 50 feet. If you are using a remote or. Another common issue related to dip switches is the fan turning on or off by itself. Once you purchase a new remote go through the necessary steps to set it up.

If the remote is sending a signal check to see if the fan and the remote are set to the same frequencies. If the fan works without the remote via a pull chain or switch but not with the remote even though they have the same settings the remote has probably gone bad and you will just have to get a replacement remote. In this case replace the reverse switch. The dip switch settings on the remote and the ones inside of the fan must be the same or there will be problems with the fan not communicating with the remote properly.

This is more likely to affect you if you live in an apartment or a townhouse. Contact the manufacturer 3. If the light is not coming on than the remote is not sending a signal. Change the battery 2.

Ceiling fan remote controls use frequencies to transmit signals which activate the ceiling fan motor and the ceiling fan light. The next possible reason why the fan is not working is to consider the remote. Try a universal remote. Confirm the reverse switch is not in a neutral position.

Check to ensure that the problem is not with the remote see fanimation remote not working guide above if the mains supply circuit. First ensure that the mains power is turned on and then check to ensure that the circuit breaker for the unit is not. When a button is pushed on the remote a red led light should light up. Flip the switch several times to make sure it is the right.

If this is happening then the battery is ok and the ceiling fan remote is functioning in a proper way. Most ceiling fan remote controls come with the factory set frequency. Hence the other remote is messing with your ceiling fan. They need to be set the same way on both the fan and the remote.

Follow the steps below to determine the cause. This can usually be done by checking the dip switches. If you have an older ceiling fan the switch may be worn out.