Simply push the post into the cement mix in the center of the hole.
Chain link fence installation method statement.
Add gravel to the bottom of the post hole for drainage.
Chain link fabric height 2 depth of post in ground total post height.
The scope of this method of statement is to cover the demolishing methodology of the following.
Method statement installation of fencing and gate 1 0 objective of procedure this work method statement covers the fencing works for your project name.
Set the line post in place against the layout line adjust it for plumb and temporarily support it in place with braces.
The purpose of this method statement is to describe the procedure which shall be followed for.
Terminal posts should be set 2 higher than the width of the fabric and line posts 2 lower than the fabric width.
The purpose of this method statement is to illustrate how the existing fence and shelters will be removed from site in proper and safe way.
This item shall consist of furnishing and erecting fencing and gates in accordance to the specifications and the details shown on the drawings or as directed by the e r.
This item shall consist of furnishing and erecting fencing and gates in accordance to the specifications and the details shown on the drawings or as directed by the e r.
Set terminal posts as tight to the string as possible without touching the string.
Civil specifications for the project and owner engineer requirements.
Run a tension bar through the links at the end of the mesh.
Lay the chain link mesh on the ground outside the fence.
Chain link fabric or mesh is usually sold in rolls 4 5 or 6 feet high.
Galvanized steel is the strongest mesh.
This will incude all the work procedures and instruction that are made by the she and kusile specifications scope this method statement will apply to the instalation of the 2 4 high welding mesh sercurity fence as per drawing supplied by eskom kusile.
Most chain link posts can be installed by actually pouring the cement in the hole first and then sticking the post in the wet cement.
Method statement installation of fencing and gate 1 0 objective of procedure this work method statement covers the fencing works for your project name.
Installation of chain link fence works to comply with schedule of finishes the general architectural.
Initially the water will sit on top but eventually will work its way to the bottom.
Set the terminal posts in concrete using a concrete mix as follows.
Mix a fairly heavy solution as too much water weakens concrete and may cause cracking.
If using fast set concrete pour the dry mix around each post to a few inches below ground level and add water.
Chain link fence internal external.
Slope it away from the post to help with water runoff.
1 part cement 2 parts sand and 4 parts gravel.
Make sure the mark you made earlier is at ground level.
Fence and gate will be doing during the kusile project.
