11 steps of chain link fence installation step 1.
Chain link fence instructions.
Chain link fence installation manual before you begin.
If using fast set concrete pour the dry mix around each post to a few inches below ground level and add water.
Use a rubber mallet to drive end post caps onto the gate corner and end.
This is easily done by stretching a string along the property line and setting the posts 4 inside.
Chain link fence posts are typically spaced a maximum of ten feet apart.
Chain link fence gate installation instructions figure 2 figure 3 figure 4 step 1 dig terminal post holes approximately 8 in diameter and 30 deep with sloping sides fig.
Follow the fence manufacturer s instructions for spacing which typically ranges from 4 10 apart spacing should not exceed 10 on center.
Leave the concrete a few inches below ground level.
There may be local zoning or deed restrictions pertaining to height and type of fence.
Slide tension bands onto each corner gate and end post.
Slope it away from the post to help with water runoff.
The exact diameter and depth will be determined by local weather and soil conditions.
Step 2 with crayon or chalk mark the ground line on posts.
The bands will help hold the mesh in place once it s installed.
For aesthetic reasons space posts evenly but do not exceed ten feet between posts.
If you plan on installing privacy slats or another type of material that will increase wind load consider using 8 or 6 post spacing.
Locate your property s line.
Find surveyors pins if the fence is to be located near property lines or have the lot surveyed.
Check all the regulations about fence setbacks type and height.
Obtain necessary zoning and building permits.
All posts should be set about 4 inches inside the line.
Put hinges and latch hardware onto the gate posts at roughly their final positions to install later.
Mark the fence location.
Once you have determined the property line and legal setback mark out the location of the fence.
Mark the fence location before you start have the local utility company mark all underground utility lines.
Also be sure to determine the property boundary and the local setback rules.
Check out your property line setback requirements.
The key point to remember with chain link fencing is that in order to achieve a rigid strong fence your posts must be concreted in line wire needs to be tensioned along the fence line and the chain link must be tensioned and secured correctly to the posts and line wire.
Most fence installers recommend that all posts be set approximately 4 inside the property line.
This will help avoid encroaching on adjoining property with concrete footings.
