Cut caulk between backsplash and vanity with utility knife.
Changing bathroom vanity top.
Disconnect the drain pipes from the existing sink unit using a pipe.
If the old vanity is marble or granite it will not be screwed on.
Find the studs and position the vanity locate the wall studs and mark them a little higher than the top of the new vanity.
Mark the placement of the new vanity s screw holes.
Measure for the new vanity top.
Studfinder tape measure level pencil drill with screwdriver bits jigsaw as needed coping saw as needed small profile gauge as needed caulk gun.
How to remove and replace a bathroom vanity top step 1.
Start by cutting off water and disconnecting and removing old fixtures.
Turn off the main water supply to the bathroom.
Measure the vanity base with a tape measure and write down the measurements.
Remove the doors from the vanity cabinet using a screwdriver to make it easier to work.
A custom vanity top maker based in georgia will design vanity tops as long as 140 inches and as deep as 30 inches.
Measure the dimensions of the existing vanity top using a tape measure.
Figure out the center every bathroom sink or vanity top has three holes cut at.